Diamond T 975a
Hello I am restoring a 1944 Diamond T 975a cargo truck,it was in the canadian army during WW2.and then given to the norwegian army.It then came to the UK where I managed to get hold of it.The engine i... »
-
Welcome to
-
Our Members Trucks
-
Who’s who
-
Guide Lamp Co. Anderson, Indiana
-
Public Submissions
-
Diamond T Truck Owners Manuals and other...
-
Diamond T Car found 9/19/06
-
Fire trucks
-
C.A.Tilt,Family photos and cars(Not Truc...
-
Historical Photos
-
Cream of the Crop
-
Diamond T Ads
Latest Activity
-
david payne replied to the topic 1948 201 King pins and bushings in the forum Sharing my little bit of knowledge! 10 years, 2 months ago
NOTE: THE N.A.P.A.(Allied) Part Number for the KING PIN SET that BELONGS in the (D T Truck) MODEL 201 is # A-310.
-
david payne replied to the topic 1948 201 King pins and bushings in the forum Sharing my little bit of knowledge! 10 years, 2 months ago
INSTALLING KING PINS and BUSHINGS by T.J. CARR ; REBUILDING the CLARK Model 250F as used on the (D T Truck) Model 201.
{continued} THE N.A.P.A. KIT does NOT come with NEW SOFT PLUGS for the TOPS and BOTTOMS of the SPINDLES, so FOUR 1.250″
Dorman PLUGS must be obtained. AS SOLD THEY WILL NOT GO BACK IN TO THE OLD RELIEFS. TURN THE APPROIATE SOCKET…[Read more] -
david payne replied to the topic 1948 201 King pins and bushings in the forum Sharing my little bit of knowledge! 10 years, 2 months ago
INSTALLING KING PINS and BUSHINGS by T.J.CARR ; REBUILDING THE CLARK MODEL 250F as used on the ( D T Truck) Model 201.
{continued} FOR assembly, put the whole works back together the way it came apart. Reinstall the original SPACER on the TOP of the AXLE, and the ORIGINAL thrust bearing goes on the BOTTOM of the AXLE. THE THRUST BEARING FIT IS…[Read more] -
david payne replied to the topic 1948 201 King pins and bushings in the forum Sharing my little bit of knowledge! 10 years, 2 months ago
INSTALLING KING PAIN and BUSHINGS by T.J.CARR ; REBUILDING THE CLARK MODEL 250F as used on the ( D T Truck) Model 201.
{continued} FOR assembly, put the whole works back together the way it came apart. Reinstall the original SPACER on the TOP of the AXLE, and the ORIGINAL thrust bearing goes on the BOTTOM of the AXLE. THE THRUST BEARING FIT IS…[Read more] -
kylyll2008 became a registered member 10 years, 2 months ago
- Load More
Latest Posts
Model 80 that was auctioned
I looked at the Diamond T model 80 that was auctioned off. I drove over early in the week to take a look at it because I had a prior commitment for that Saturday. It was a very restorable truck and co... »
1948 Diamond T and SEABISCUIT
Hello Bill! Thought the following press release might be of interest to you. As you may already be well aware, the 1948 Diamond T Classic as seen on your website was believed to have been owned by Cha... »